What are the installation steps for a smart health-care bed? ?

The installation steps for the smart health-care bed are as follows: 1. Two brake locks are installed on the casters of the smart health-care bed; these two braked casters are diagonally mounted in the screw holes on the bed frame legs. The remaining two casters are then installed in the screw holes on the other two base legs.

2. Rear bed panel installation: Connect the rear bed panel to the bed frame using the rear frame pin, then secure the pin with a cotter pin.

3. Installation of the smart health-care bedside unit: Align the holes on both sides of the bedside unit with those on the back of the bed, insert the unit, and tighten the securing screws on both sides.

4. Installation of the rear air spring: Lift the rear bed upward by 90 degrees, screw one end of the rear air spring into the air-spring support bracket at the bottom of the rear bed, connect the lower air-spring support bracket to the U-shaped bed frame using a pin, and then secure the pin with a cotter pin.

5. Install the air springs on the side of the smart health-care bed, then press the side control button to set the side bed to a horizontal position.

6. Installation of the smart health-care bed’s foot-end panel: First, flip the foot-end panel over; use pivot pins to connect the tubular connectors to the support brackets on the connectors, and secure them with cotter pins. Then, tighten the screws on both sides of the tubular connector slide bracket, aligning the holes on the slide bracket with the corresponding screw holes on the tubular connectors, and finally tighten the screws using a wrench. Next, take the connecting holes at the joint between the foot-end panel and the thigh-end panel, pass the triangular bracket pivot pin through these holes, and secure it with a cotter pin.

7. Install the foot guardrails: Secure the two foot guardrails into the mounting holes on the surface of the footboard, then screw them in and tighten.

8. Installing the safety belt: Remove the safety belt, loop it around the seat cushion on the smart healthcare bed, and pass it through the two limit holes on the headboard.

Precautions for Using a Smart Wellness Bed

1. When the left–right flipping function is required, the bed surface shall be in a horizontal position; similarly, when the rear bed surface is raised or lowered, the side bed surface will also descend to a horizontal position.

2. When the patient is defecating in a seated position, using a wheelchair, or having their feet washed, the back section of the bed should be raised. Before performing these procedures, ensure that the thigh section of the bed is elevated to an appropriate height to prevent the patient from slipping.

3. Do not operate the smart health-care bed on rough, uneven roads or park it on sloped surfaces.

4. Apply a small amount of lubricant to the nuts and pins each year.

5. Regularly inspect the alignment of the smart wellness bed’s pivot pins, screws, and guardrails to prevent loosening or detachment.

6. Do not push or pull the gas springs of the smart health-care bed.

7. Do not forcibly operate drive components, such as the screw; if a malfunction occurs, have it repaired before use.

8. When lifting the footrest, first tilt it slightly upward, then lift the control handle to prevent the handle from breaking.

9. Sitting at either end of the bed is prohibited.

10. Please fasten your seatbelt; children are not permitted to operate the device. In general, the smart health-care bed comes with a one-year warranty.